ruleswhe.blogg.se

Plywood template for anchor bolts
Plywood template for anchor bolts













plywood template for anchor bolts plywood template for anchor bolts

Templates are the same for 4" or 6" thick walls.įoundation design and construction for Pre-Engineered Buildings are important to the assembly process.Templates are recommended and are required in some jurisdictions.For RF Raised-Floor walls, use the corresponding Standard Wood Strong-Wall shearwall template as required.Allow 1 1/2" or 3" of concrete on either side of the template if the design is for a wood 1st-floor or 2nd-floor application. Raised-Floor Wood Strong-Wall ® shearwalls require 1 1/2" or 3" of concrete on either side.See Garage Portal for curb height tables.The height of the garage curb above the garage slab is critical for rough header opening on portal walls.SSWTBL Brick Ledge Concrete Template Installation Video SSWTPF Panel Form Concrete Template Installation Video SSWT Concrete Template Interior Installation Video SSWT Concrete Template Exterior Installation Video Steel Strong-Wall Anchor Bolt Template Installation Videos Immediately following concrete placement, the dowels are removed and reused in other locations. Half-inch diameter dowels (not supplied) are then driven down through the bolt stabilizers and into the ground to ensure plumb installation of the anchors and prevent movement during concrete placement. Two bolt stabilizers are used for each SSW anchor assembly one at the embedded plate washer and the other above the template. The bolt stabilizer enables the Steel Strong-Wall anchorage to be installed without being tied to the footing rebar cage by helping to eliminate movement of the anchor bolts during concrete placement. Simpson Strong-Tie now offers anchor bolt stabilizers that may be used with all anchor template models.















Plywood template for anchor bolts